How to print ASA filament
ASA is a great outdoor material once your printer is set up for it. Here is a starting point.
Typical starting settings
| Nozzle temperature | About 235–260 °C |
|---|---|
| Bed temperature | About 90–110 °C |
| Part cooling fan | Off or low for most layers; a little more for bridges and overhangs |
| Enclosure | Strongly recommended |
| Print speed | Start moderate; slow the first layer |
These ranges are general guidance only. Every brand and color behaves a little differently, so start with your filament maker's recommended settings and adjust from there.
1. Use an enclosure
ASA shrinks as it cools. If the air around the print is cold or drafty, the outer layers cool faster than the inside and pull the corners up or split the layers apart. An enclosure keeps the air warm and still. It can be a printer with a built-in enclosure, a ready-made tent, or another enclosure designed for your printer. Let the enclosure warm up with the bed on for a while before you start.
2. Get the first layer right
- Clean the bed. Oils from fingers are a common cause of poor adhesion.
- Use a surface that works for ASA on your printer, such as textured PEI, or a thin layer of glue stick or a purpose-made adhesive.
- Add a brim on parts with sharp corners or a small footprint.
- Print the first layer slowly and slightly warmer.
3. Keep cooling low
Strong part cooling makes layers bond poorly and can cause cracks. Start with the fan off or very low, and only add more if overhangs or bridges sag.
4. Design for less warping
- Round sharp corners with a fillet where you can.
- Avoid long, thin, flat parts when possible, or split them into sections.
- Use enough walls and infill so the part holds its shape as it cools.
5. Fumes and ventilation
ASA, like ABS, gives off a noticeable smell and fumes while it prints. Print in a well-ventilated space, not a bedroom or a small closed room where people spend time. An enclosure with a filter or a vent to the outside helps keep fumes out of the room. Follow your printer and filament makers' safety guidance.
6. Let the print cool slowly
When the print finishes, leave it in the closed enclosure until it cools. Opening the door right away can cause last-minute cracks.
Storage
ASA is less sensitive to humidity than nylon, but any filament can pick up moisture over time. If you notice popping, extra stringing, or a rough surface, try drying the spool following the maker's guidance and store it sealed with desiccant.
Still seeing lifted corners? See fixing warping and cracking.