How to print ABS filament
ABS is tough, heat resistant, and easy to finish. It just needs a warm, steady environment.
Typical starting settings
| Nozzle temperature | About 220–250 °C |
|---|---|
| Bed temperature | About 95–110 °C |
| Part cooling fan | Off or low; a little more for bridges |
| Enclosure | Strongly recommended |
| First layer | Slow, with a brim on corners |
These ranges are general guidance only. Every brand and color behaves a little differently, so start with your filament maker's recommended settings and adjust from there.
1. Warm, still air
ABS shrinks more than PLA or PETG as it cools. Drafts from a fan, an open window, or air conditioning can make corners lift and layers crack. An enclosure that holds the heat from the bed makes the biggest difference. Preheat with the bed on and the door closed before you start.
2. Bed adhesion
- Clean the build surface before each print.
- Textured PEI, glue stick, or an ABS-specific adhesive are common choices. Check what your bed maker recommends.
- Use a brim for parts with sharp corners, and consider a draft shield in your slicer if you don't have an enclosure.
3. Cooling and layer bonding
Keep the part cooling fan off or low. Too much airflow weakens the bond between layers. If your layers split easily, raise the nozzle temperature a little and reduce cooling.
4. Ventilation
ABS has a strong smell while printing and releases fumes and fine particles. Print in a well-ventilated area away from where people sleep or spend long periods. A filtered or vented enclosure is a good upgrade. Follow your printer and filament makers' safety guidance.
5. Acetone smoothing (optional)
ABS can be smoothed using acetone-based finishing methods for a glossy finish, and acetone can be used to glue ABS parts together. Acetone is highly flammable. Work in a well-ventilated area, away from heat, sparks, and flames, and follow the safety instructions on the product.
6. After the print
Leave the print in the closed enclosure to cool down slowly before removing it.
Storage
ABS is less sensitive to humidity than nylon, but spools can still pick up moisture. If prints start popping or stringing, dry the spool following the maker's guidance and store it sealed with desiccant.